Publication detail

Influence of the Cut Direction through the Semi-Finished Product on the Occurrence of Cracks for X210Cr12 Steel Using WEDM

MOURALOVÁ, K. KLAKURKOVÁ, L. MATOUŠEK, R. PROKEŠ, T. HRDÝ, R. KAŇA, V.

Original Title

Influence of the Cut Direction through the Semi-Finished Product on the Occurrence of Cracks for X210Cr12 Steel Using WEDM

Type

journal article in Web of Science

Language

English

Original Abstract

Wire electrical discharge machining (WEDM) is a key technological process for the production of parts from semi-finished products to the final heat treatment as it also enables the machining of very hard material. The quality of an electro-erosive machined surface is a very important factor with regard to the consequent functionality and life cycle of the manufactured part. The occurrence of cracks or burned cavities is therefore an acceptable defect of the sub-surface area, which along with residual stress may lead to the destruction of the machining. This study deals with the influence of the cut direction through a semi-finished product on the occurrence of defects (cracks, burned cavities) regarding the influence of setting up the parameters of the machine (gap voltage, pulse on and off time, wire feed and discharge current) and the type of heat treatment of the material. In order to study the surface and sub-surface area of the machined samples, electron microscopy was used, including the use of the local EDX chemical analysis.

Keywords

WEDM; electrical discharge machining; steel X210Cr12; morphology; topography; recast layer; cracks

Authors

MOURALOVÁ, K.; KLAKURKOVÁ, L.; MATOUŠEK, R.; PROKEŠ, T.; HRDÝ, R.; KAŇA, V.

Released

1. 9. 2018

Publisher

Elsevier

Location

Polsko

ISBN

1644-9665

Periodical

ARCH CIV MECH ENG

Year of study

18

Number

4

State

Republic of Poland

Pages from

1318

Pages to

1331

Pages count

14

URL

BibTex

@article{BUT146745,
  author="Kateřina {Mouralová} and Lenka {Klakurková} and Radomil {Matoušek} and Tomáš {Prokeš} and Radim {Hrdý} and Václav {Kaňa}",
  title="Influence of the Cut Direction through the Semi-Finished Product on the Occurrence of Cracks for X210Cr12 Steel Using WEDM",
  journal="ARCH CIV MECH ENG",
  year="2018",
  volume="18",
  number="4",
  pages="1318--1331",
  doi="10.1016/j.acme.2018.04.004",
  issn="1644-9665",
  url="https://www.sciencedirect.com/science/article/pii/S1644966518300451"
}