Publication detail

INFLUENCE OF DEFORMATION TEMPERATURE AND STRAIN RATE ON THE MAXIMUM FLOW STRESS LEVEL OF THE 3D PRINTED AISI 316L STEEL

Opěla Petr, Benč Marek

Original Title

INFLUENCE OF DEFORMATION TEMPERATURE AND STRAIN RATE ON THE MAXIMUM FLOW STRESS LEVEL OF THE 3D PRINTED AISI 316L STEEL

Type

conference paper

Language

English

Original Abstract

The AISI 316L stainless steel is one of the most used 3D printed powder materials due to its good properties. It goes without saying that the properties of the 3D printed steel are naturally less or more different compared to the material which was prepared conventionally. One of the important material characteristics is its flow stress evolution under various thermomechanical circumstances, which has a direct connection to the deformation behavior. The hot deformation behavior of the examined 3D printed steel is in the frame of the submitted research studied with regard to the peak stress levels experimentally achieved under a wide temperature and strain rate range, as well as from the point of view of the onset of a dynamic softening phenomenon - in addition with an emphasis on the corresponding mathematical description. The obtained results indicate a minimal and maximal flow stress level of 65 MPa and 381 MPa as for the combination of 1,523 K - 0.1 s(-1) and 1,173 K - 100 s(-1), respectively. The experimentally achieved peak point coordinates have been described with a good accuracy - corresponding to the Pearson's correlation coefficient of 0.8238 and 0.9919 as regards to the peak strain and peak stress, respectively.

Keywords

AISI 316L steel; 3D printing; hot deformation; peak stress; softening onset

Authors

Opěla Petr, Benč Marek

Released

12. 7. 2024

Publisher

TANGER LTD

Location

SLEZSKA

ISBN

978-80-88365-12-9

Book

Metal 2023

Pages from

188

Pages to

191

Pages count

4

URL

https://www.confer.cz/metal/2023/4637-influence-of-deformation-temperature-and-strain-rate-on-the-maximum-flow-stress-level-of-the-3d-printed-aisi-316l-steel

BibTex

@inproceedings{BUT197245,
  author="Marek {Benč}",
  title="INFLUENCE OF DEFORMATION TEMPERATURE AND STRAIN RATE ON THE MAXIMUM FLOW STRESS LEVEL OF THE 3D PRINTED AISI 316L STEEL",
  booktitle="Metal 2023",
  year="2024",
  pages="188--191",
  publisher="TANGER LTD",
  address="SLEZSKA",
  doi="10.37904/metal.2023.4637",
  isbn="978-80-88365-12-9",
  url="https://www.confer.cz/metal/2023/4637-influence-of-deformation-temperature-and-strain-rate-on-the-maximum-flow-stress-level-of-the-3d-printed-aisi-316l-steel"
}