Czech

Not applicable.

Basic knowledge of circuits in harmonic steady state, usage of RC, RL and RLC resonant circuits, three-phase networks, transients in linear circuits and transmission lines as preparation for the study in following courses.
Qualification level in electrical engineering "competent worker".

The subject knowledge on the secondary school level is required.

Not applicable.

Teaching methods depend on the type of course unit as specified in the article 7 of BUT Rules for Studies and Examinations.

Total number of points is 100, including 2 x 12 points in two written tests in exercises, 6 points for laboratory course test and 70 points for final exam. All laboratory measurements are obligatory - to obtain credit it is necessary to measure all of laboratory exercises and to obtain 15 points from maximum 30. Requirements for completion of a course are: to gain credit and to perform an exam. Minimal necessary achieved total mark to pass this course is 50 points.

1. Harmonic variables in electric ciruits, phasors, impedances and admitances
2. Symbolic method of linear circuit analysis in harmonic steady-state, power in harmonic steady state
3. Method of source substitution, current loops method, node voltages method
4. Properties of passive linear circuits of 1. order (RC, RL)
5. Properties of passive linear circuits of 2. order (RCL)
6. Three-phase circuits
7. Power in three-phase circuits
8. Transient processes in linear circuits of 1. and 2. order
9. Analysis of transient processes based on Laplace transform
10. Transient processes non-zero initial conditions, transient and impulse response of linear circuits
11. Transmission lines and its primary and secondary parameters
12. Harmonic steady state on transmission lines, waves, impedance, transient processes on transmission lines
13. Recapitulation, time reserve

Not applicable.

The course develops the knowledge gained in EL1 (Electrical Engineering 1) in the 1st term of study and prepares the students for following courses of specializations in electrical engineering. Laboratory measurements and numerical exercises help in verifying theory taught in lectures. In last week students will be examined to obtain qualification level "competent worker".

The content and forms of instruction in the evaluated course are specified by a regulation issued by the lecturer responsible for the course and updated for every academic year.

Not applicable.

Not applicable.

KALÁB, P.; STEINBAUER, M.; VESELÝ, M. Bezpečnost v elektrotechnice. Brno: Ing. Zdeněk Novotný, CSc, Ondráčkova 105, 628 00 Brno, 2009. s. 1-68. ISBN: 978-80-214-3952- 8. (CS)
SEDLÁČEK, J.; MURINA, M.; STEINBAUER, M.; KROUTILOVÁ, E. Elektrotechnika 2 - laboratorní a počítačová cvičení. BRNO, Ing. Zdeněk Novotný, CSc., Ondráčkova 105, 628 00 Brno. 2008. p. 1 - 160. ISBN 978-80-214-3575-9. (CS)

MIKULEC, M., HAVLÍČEK, V.:Základy teorie elektrických obvodů, ČVUT Praha 2003 (CS)