Detail publikace

Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel

MOURALOVÁ, K. MATOUŠEK, R. KOVÁŘ, J. MACH, J. KLAKURKOVÁ, L. BEDNÁŘ, J.

Originální název

Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel

Typ

článek v časopise ve Web of Science, Jimp

Jazyk

angličtina

Originální abstrakt

The efficient wire electric discharge machining (WEDM) technology is an efficient trade-off between the cutting speed and the resulting surface quality. A typical morphology of a surface machined using WEDM contains a large number of craters caused by the electric sparks generated in the cutting process. The paper analyzes the influence of the cutting speed on the quantitative and qualitative evaluation of the surface craters formed on the surface of a workpiece made of the 16MnCr5 steel. Applying metallography to cross-section microscopic slides, diffusion subsurface damages were studied caused by the cutting. The diffusion processes taking place between the electrode and the material machined were studied using a local point EDX microanalysis applied both to the machined surfaces and to the cross sections. A detailed study was also carried out of the brass electrode to measure its wear rate caused by the cutting process as well as its degradation in terms of the quality of its morphology and the chemical composition of surface.

Klíčová slova

WEDM, electrical discharge machining, design of experiment, surface investigation, metallography, EDX

Autoři

MOURALOVÁ, K.; MATOUŠEK, R.; KOVÁŘ, J.; MACH, J.; KLAKURKOVÁ, L.; BEDNÁŘ, J.

Vydáno

1. 12. 2016

Místo

Spojené státy americké

ISSN

0263-2241

Periodikum

MEASUREMENT, Journal of the International Measurement Confederation (IMEKO)

Ročník

2016

Číslo

94

Stát

Spojené království Velké Británie a Severního Irska

Strany od

771

Strany do

779

Strany počet

9

URL

BibTex

@article{BUT128110,
  author="Kateřina {Mouralová} and Radomil {Matoušek} and Jiří {Kovář} and Jindřich {Mach} and Lenka {Klakurková} and Josef {Bednář}",
  title="Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel",
  journal="MEASUREMENT, Journal of the International Measurement Confederation (IMEKO) 
",
  year="2016",
  volume="2016",
  number="94",
  pages="771--779",
  doi="10.1016/j.measurement.2016.09.028",
  issn="0263-2241",
  url="http://authors.elsevier.com/sd/article/S0263224116305310"
}