Detail publikace

3D printing of a patch antenna for 5G network and radio monitoring of UWB signals

VANĚK, S. POPELA, M. OLIVOVÁ, J. VAVREČKOVÁ, K.

Originální název

3D printing of a patch antenna for 5G network and radio monitoring of UWB signals

Typ

článek ve sborníku ve WoS nebo Scopus

Jazyk

angličtina

Originální abstrakt

The article deals with the fabrication of a patch antenna using 3D printing. PLA material and conductive (copper) spray for coating the conductive parts were used to produce the antenna. The produced antenna has the same parameters as the antenna made from RF/duroid 5880 substrate. The experiment showed that the antenna produced by 3D printing is functional and has good radiation characteristics. In the presented paper, the design, simulation and fabrication of the speckle antenna using two materials (RF/duroid 5880 and PLA material and surface sprayed with copper spray) are described. The fabricated patch antennas are experimentally tested and their properties are compared.

Klíčová slova

patch antenna, antenna radiation patterns, RF/duroid 5880 substrate, 3D printing, filaments, material PLA

Autoři

VANĚK, S.; POPELA, M.; OLIVOVÁ, J.; VAVREČKOVÁ, K.

Vydáno

26. 5. 2023

Nakladatel

IEEE

Místo

Brno, Czech Republic The 9th International Conference on Military Technologies (ICMT)

ISBN

979-8-3503-2568-3

Kniha

International Conference on Military Technologies, ICMT 2023

Strany počet

5

URL

https://www.icmt.cz/

BibTex

@inproceedings{BUT183586,
  author="Stanislav {Vaněk} and Miroslav {Popela} and Jana {Olivová} and Keteřina {Vavrečková}",
  title="3D printing of a patch antenna for 5G network and radio monitoring of UWB signals",
  booktitle="International Conference on Military Technologies, ICMT 2023",
  year="2023",
  pages="5",
  publisher="IEEE",
  address="Brno, Czech Republic
The 9th International Conference on Military Technologies (ICMT)",
  doi="10.1109/ICMT58149.2023.10171332",
  isbn="979-8-3503-2568-3",
  url="https://www.icmt.cz/"
}