Detail publikace

Problems of computer simulation in metal forming

NOVOTNÝ, K.

Originální název

Problems of computer simulation in metal forming

Typ

článek ve sborníku ve WoS nebo Scopus

Jazyk

angličtina

Originální abstrakt

In the present, the application of computer simulation is increasing very fast. So far, it has been used relatively little for diverse reasons, such as high cost, demands on hardware, experienced staff, in some cases certain software deficiencies, etc. Today, however, it is no longer possible to work without these simulations since the requirements for the quality of manufactured components are steadily increasing. At Brno University of Technology two software program are mainly used: DEFORM 2D + 3D and the Czech FORMFEM program. The paper analyses the main reasons why simulation should be used and what experience and knowledge of simulation have so far been obtained. A practical example of the production of a canvas ring (i.e. a ring used in canvas covers) of sheet metal is given, inclusive of the simulation and a comparison with experimental test results, which have fully confirmed the simulation results.

Klíčová slova v angličtině

Computer simulation, metal forming, DEFORM, FORFEM

Autoři

NOVOTNÝ, K.

Rok RIV

2002

Vydáno

23. 10. 2002

Nakladatel

Metal forming laboratory of the Federal university of Rio grande do sul

Místo

Gramado - Brasil

ISBN

XXXX

Kniha

V. national conference on sheet metal forming

Strany od

20

Strany do

25

Strany počet

6

BibTex

@inproceedings{BUT9638,
  author="Karel {Novotný}",
  title="Problems of computer simulation in metal forming",
  booktitle="V. national conference on sheet metal forming",
  year="2002",
  pages="6",
  publisher="Metal forming laboratory of the Federal university of Rio grande do sul",
  address="Gramado - Brasil",
  isbn="XXXX"
}