Detail publikace

Mechanical Properties, Structure and Machinability of the H13 Tool Steel Produced by Material Extrusion

MALÝ, M. KOLOMÝ, Š. KASAN, R. BARTL, L. SEDLÁK, J. ZOUHAR, J.

Originální název

Mechanical Properties, Structure and Machinability of the H13 Tool Steel Produced by Material Extrusion

Typ

článek v časopise ve Web of Science, Jimp

Jazyk

angličtina

Originální abstrakt

The study focuses on an evaluation of mechanical properties of the H13 tool steel manufactured by the material extrusion and further comparison with conventionally produced material. Notably, for achieving sufficient surface quality of functional parts further post-processing is required. Thus, a comprehensive investigation, encompassing hardness, ultimate tensile strength (UTS) and yield strength (YS) measurement, microstructure, and machinability was performed. The material extrusion, an increasingly utilized additive manufacturing (AM) technique, offers a viable alternative to the prevalent laser powder bed fusion (LPBF) methods. The investigation revealed that the horizontal orientation of parts yielded the highest mechanical properties, reaching the ultimate tensile strength of approximately 1200 MPa. Additionally, the material exhibited the hardness of 47 HRC in the as-built state. The conventionally produced steel resulted in the higher UTS and YS in comparison to the AM material. The machinability of the as- built material in regard to cutting forces and surface roughness was also evaluated Lower surface roughness was achieved by decreasing feed per tooth. Optically measure material porosity was 6.13 % with maximum pore size 7.43 mu m. The primary objective of this research is to optimize the mechanical properties of H13 tool steel post-printing, with a broader aim to apply the gained insights to improve other materials produced by the material extrusion.

Klíčová slova

Material Extrusion; H13 Tool Steel; Additive Manufacturing; Microstructure; Mechanical Properties

Autoři

MALÝ, M.; KOLOMÝ, Š.; KASAN, R.; BARTL, L.; SEDLÁK, J.; ZOUHAR, J.

Vydáno

8. 7. 2024

Nakladatel

Jan Evangelista Purkyne Univ

Místo

Usti nad Labem

ISSN

2787-9402

Periodikum

Manufacturing Technology

Ročník

24

Číslo

4

Stát

Česká republika

Strany od

608

Strany do

617

Strany počet

10

URL

http://www.journalmt.com

BibTex

@article{BUT189731,
  author="Martin {Malý} and Štěpán {Kolomý} and Radek {Kasan} and Lukáš {Bartl} and Josef {Sedlák} and Jan {Zouhar}",
  title="Mechanical Properties, Structure and Machinability of the H13 Tool Steel Produced by Material Extrusion",
  journal="Manufacturing Technology",
  year="2024",
  volume="24",
  number="4",
  pages="608--617",
  doi="10.21062/mft.2024.066",
  issn="2787-9402",
  url="http://www.journalmt.com"
}