Přístupnostní navigace
E-přihláška
Vyhledávání Vyhledat Zavřít
Detail publikace
ŠEVČÍK, M. HUTAŘ, P. NÁHLÍK, L. KNÉSL, Z.
Originální název
The effect of polymer pipe weld geometry on creep lifetime
Typ
článek v časopise - ostatní, Jost
Jazyk
angličtina
Originální abstrakt
In the case of large diameter HDPE and polypropylene (PP) pipes the most usual joint is butt weld. Usually, a good quality of a butt welded joint means that strength of the joint should be about the same as valid for the basic pipe material. In reality geometry, morphology and material structure of welded joints on micro- and macro-level are more complicated in comparison with the base homogeneous pipe material. The formation of weld structure is highly dependent on both thermal history and corresponding stress state. The geometry of the weld and change of the material properties inside the weld can change failure resistance of the pipe system. The primary objective of this work is to estimate the influence of weld deposit geometry on the failure assessment of the welded polymer pipes under creep loading. To this aim an overlay of the material near the weld is modeled as a notch and corresponding stress distribution and its triaxiality is analyzed. The calculations are performed for real geometry of the butt weld and can help estimate lifetime of the structures considered.
Klíčová slova
creep, stress concentration factor, lifetime, triaxiality
Autoři
ŠEVČÍK, M.; HUTAŘ, P.; NÁHLÍK, L.; KNÉSL, Z.
Rok RIV
2011
Vydáno
5. 1. 2011
Nakladatel
Trans Tech Publications
Místo
Switzerland
ISSN
1013-9826
Periodikum
Key Engineering Materials (print)
Ročník
465
Číslo
-
Stát
Švýcarská konfederace
Strany od
175
Strany do
178
Strany počet
4
BibTex
@article{BUT50878, author="Martin {Ševčík} and Pavel {Hutař} and Luboš {Náhlík} and Zdeněk {Knésl}", title="The effect of polymer pipe weld geometry on creep lifetime", journal="Key Engineering Materials (print)", year="2011", volume="465", number="-", pages="175--178", issn="1013-9826" }