Czech

Not applicable.

Students acquire experience in processing of design a single product, on the basis of the analysis and input data. Students will also learn to present the results of work through digital technology.

Completion of courses "Workshop - Industrial design I" is assumed.Students are assumed to have mastered the fundamentals of drawing and moulding necessary for project presentation, understanding of the basic spatial creation, art composition and realisation of three-dimensional models. Mastering designer’s solution of simpler industrial products is also expected. Knowledge of program Rhinoceros 3D, Photoshop or CorelDraw is desirable.

Not applicable.

Creative work in ateliers.

Graded course-unit credit requirements: attendance at lessons, handing over assigned projects by the deadline in a sufficient quality. Presentation of an elaborated project. Design and the level of presentation of each project are evaluated separately.
Resulting evaluation consists of evaluations on projects and exclusive tasks. In total it will be possible to aquire 100 points. Resulting classification will be defined by the ECTS scale.
If some of the projects are awarded less than half of the maximum pts., final evaluation of the course is "failed".
According to the article No. 13 of Study and Examination Rules of Brno University of Technology ECTS evaluation degree scale is used. . If some of the projects are awarded less than 50 pts., final evaluation of the course is "failed". The course is evaluated with the following grades: ECTS EVALUATION DEGREES / PTS. RATING / NUMERIC RATING: A / 100 - 90 / 1 / Excellent; B /89 - 80 / 1,5 / Very good; C / 79 - 70 / 2 / Good; D / 69 - 60 / Satisfactory; E / 59 - 50 / Sufficient; F / 49 - 0 / 4 / Failed.

Not applicable.

Not applicable.

The aim of the subject is to develop the abilities of the students to design a product with a simple function, enlarge their knowledge of basic atributes of design of industrial products and support gaining the necessary habits, mind processes and development of basic abilities including working with digital technologies. The aim is to give and develop in the students the notion of respecting technical, operational and technological aspects of designing.

The attendance in workshops is controlled. Students are required to attend workshops in scheduled hours, work on given projects and wait for consultation, unless a lecturer gives any other individual plan. Students have to inform the lecturer in advance about his working-place in the scheduled education time (studio, workshops, modelling room) - absence is not excused without this information. The absences are possible only due to serious reasons, e.g. illness. Unexcused absence may cause the project is not accepted. The total absence greater than 50% (including excused absence) may threaten project acceptance.

Not applicable.

Not applicable.

FIELL, Charlotte a Peter FIELL (eds.). Designing the 21st century: design des 21. Jahrhunderts Le design du 21 siécle. Köln: Taschen, c2001. ISBN 3-8228-5883-8. (EN)
PELCL, Jiří. Design: od myšlenky k realizaci = from idea to realization. V Praze: Vysoká škola uměleckoprůmyslová v Praze, c2012. ISBN 978-80-86863-45-0. (CS)
REYFUSS, Henry. Designing for people. New York: Allworth Press, 2003. ISBN 1581153120. (EN)

Design trend: evropská revue soudobého designu. Brno: Design centrum České republiky, 2007. ISSN 1210-1591.
FIELL, Charlotte a Peter FIELL. Industrial design. Praha: Slovart, c2003. ISBN 3-8228-2426-7.
MALANIUK, Bohdan. Design v architektuře a stavebnictví: z dějin průmyslového designu. Praha: ČVUT, 1991.