Detail publikačního výsledku

Optimalization of WEDM settings parameters when machining pure aluminium using DoE

MOURALOVÁ, K.; KOVÁŘ, J.; PROKEŠ, T.; BEDNÁŘ, J.; HRABEC, P.

Originální název

Optimalization of WEDM settings parameters when machining pure aluminium using DoE

Anglický název

Optimalization of WEDM settings parameters when machining pure aluminium using DoE

Druh

Článek Scopus

Originální abstrakt

The unconventional wire electric discharge machining technology (WEDM) is widely used in many industries, which is why thereis a permanent emphasis on increasing the quality of such machined surface. The aim of this studywas to carry out a design of experiment (DoE) to reduce the surface qualityparameterPq. During the 33-round experiment, the input factors – machine setting parameters, such as gap voltage, pulse on time, pulse off time, wire speed, and dischargecurrent, werechanged. Subsequently, Pq – rootmean square deviation of the primary profile and Pa – arithmetic average of the primary profile were evaluated on the machined surfaces of pure aluminium. By using DoE, the setting of the machine’ sparameters was designed in order to achieve the highest possible surface quality.

Anglický abstrakt

The unconventional wire electric discharge machining technology (WEDM) is widely used in many industries, which is why thereis a permanent emphasis on increasing the quality of such machined surface. The aim of this studywas to carry out a design of experiment (DoE) to reduce the surface qualityparameterPq. During the 33-round experiment, the input factors – machine setting parameters, such as gap voltage, pulse on time, pulse off time, wire speed, and dischargecurrent, werechanged. Subsequently, Pq – rootmean square deviation of the primary profile and Pa – arithmetic average of the primary profile were evaluated on the machined surfaces of pure aluminium. By using DoE, the setting of the machine’ sparameters was designed in order to achieve the highest possible surface quality.

Klíčová slova

WEDM, electrical discharge machining, Design of Experiment, P-parameters, root mean square deviation of the primary profile Pq, pure aluminium

Klíčová slova v angličtině

WEDM, electrical discharge machining, Design of Experiment, P-parameters, root mean square deviation of the primary profile Pq, pure aluminium

Autoři

MOURALOVÁ, K.; KOVÁŘ, J.; PROKEŠ, T.; BEDNÁŘ, J.; HRABEC, P.

Rok RIV

2018

Vydáno

02.09.2017

Nakladatel

MM Science Journal

Místo

Praha

ISSN

1803-1269

Periodikum

MM Science Journal

Svazek

2017

Číslo

4

Stát

Česká republika

Strany od

2105

Strany do

2108

Strany počet

4

URL

http://www.mmscience.eu/content/file/archives/MM_Science_201795.pdf

BibTex

@article{BUT138910,
  author="Kateřina {Mouralová} and Jiří {Kovář} and Tomáš {Prokeš} and Josef {Bednář} and Pavel {Hrabec}",
  title="Optimalization of WEDM settings parameters when machining pure aluminium using DoE",
  journal="MM Science Journal",
  year="2017",
  volume="2017",
  number="4",
  pages="2105--2108",
  doi="10.17973/MMSJ.2017\{_}12\{_}201795",
  issn="1803-1269",
  url="http://www.mmscience.eu/content/file/archives/MM_Science_201795.pdf"
}